Tuesday, January 26, 2010
Apple Tablet "iSlate" Perhaps?????
Wednesday, January 13, 2010
SEIKO 5 #SNK617K1 Watch
Sunday, January 10, 2010
"Old Dogs" movie review
Saturday, January 9, 2010
USB wall plug charger for Iphone
Sunday, January 3, 2010
"Erase all content and Settings" in Iphone
Iphone 2g Jailbreak with 3.1.2 firmware
1. Before doing anything, make sure you have the latest version of iTunes and the latest firmware 3.0 3.1.2 installed on your iPhone 2G.
2. Create a new folder on your desktop. In this folder, download RedSn0w as well as the 3.0 firmware (not 3.1.2) for your iPhone 2G from our iPhone downloads page (make sure you pick the right firmware). Also download the following bootloader files: BL 3.9 and BL 4.6
3. Unzip and launch RedSn0w.
4. Click “browse” and select the 3.0 (not 3.1.2) firmware you downloaded in a folder in step 2.
5. Once the firmware has been successfully identified, click “next”.
6. Select “install Cydia” and “unlock”, then click “next”.
7. Browse for the bootloader files you downloaded in step 2, and click “next”.
8. Make sure your iPhone is plugged into the computer and that it is off. Click “next”.
9. RedSn0w will then guide you to put your iPhone into DFU mode. Hold down the power button for 2 seconds. Without releasing the power button, also hold down the home button for 10 seconds. Without releasing the home button, release the power button but keep holding the home button for 30 seconds.
10. If done correctly, your iPhone should reboot and the jailbreak process should start. This step may take up to 15-20 minutes so be patient.
11. Once this process is over, you will get a message saying that it is “done!”
12. Click the “finish” button and reboot your iPhone. The reboot may take up to 10 minutes so again, be patient.
13. Congratulations, you just jailbroke and unlocked your iPhone 3.0 3.1.2 with RedSn0w.
2. Go to setting, carrier. It will search for network. (if no carier show, go back home and wait a while). wait till all 3 network found. (leave the right tick to default "automatic")
3. Press power button (put iphone on standy NOT OFF).
4. Replace the simcard with celcom. (the msg no sim will pop up.. just ignore it and just press the power button to put it on standby mode again)
5. Press power button then 'slide to unlock' You will see the network list. Choose celcom and go home.. Never enter carrier menu again.
Note: on step 5 you need to unlock (keying sim card pin) 1st if you enable the sim lo